05-08 Dana 60 Weld On High Steer Arms - Ford Super Duty

05-08 Dana 60 Weld On High Steer Arms - Ford Super Duty

Rated 4.0 out of 5

Based on 2 reviews

SKU: 2252

$99.95

Need weld on high steer arms for your Ford Dana 60? At TMR Customs we offer driver and passenger side arms that are compatible with both crossover and full hydraulic steering set ups.

CNC laser cut from 1/4" steel, includes 1" grade 8 knuckle tie in bolt
Compatible with 1-1/2" or 1-3/4" OD tie rods
Will clear stock and aftermarket low profile diff covers using straight rod ends/heims
Fabrication skills (drilling, fitting, welding) required for install
Kit requires 4-1/4" or less backspace on a 17" or larger wheel
Does not include heim joints or 3/4" bolts

Need a steering kit to fit your weld on arms? CLICK HERE

Side

Driver Side Arm

Passenger Side Arm

Both Driver & Passenger Side Arms

We're wheelers too - we back every product with the TMR Customs quality guarantee. Our products are designed to be the ultimate in durability and withstand years of abuse. So go ahead and abuse them in the dirt and rocks - just as they were intended!

Our Return Policy

Designed, manufactured and tested by true off road enthusiasts!

Write a Review

average rating 4.0 out of 5

Based on 2 reviews

5 Stars

1 Review
4 Stars

0 Reviews
3 Stars

1 Review
2 Stars

0 Reviews
1 Star

0 Reviews

100% of reviewers would recommend this product to a friend

2 Reviews

Sort by

Reviewed by Lucas M.

Verified Buyer

I recommend this product

Rated 3 out of 5

Review posted

Weld on high steer arms

Quality of the product looks to be good havent installed yet only dry fit. Gave a 3 star because the buy page defaults to driver side high steer arm and I didnt catch it until the package arrived had to make a separate order with the other side should default to both in my opinion

Was this helpful?

TMR Customs Inc.

Thanks for the feedback Lucas.

Reviewed by Steve T.

Verified Buyer

I recommend this product

Rated 5 out of 5

Review posted

Badasserthanhell

I was pumped to see they used P/O steel as well as grade 8 fine thread hardware although a stover nut would be more my style, nylock is ok if you service a lot!

Fit was precise but be careful when you drill out the factory holes for 3/4” hardware need to keep everything in the right plane. I recommend having a machine shop bore it out your cordless dewalt and princess auto drill bit are not the best for this application.

Good shelf for weld material along the outside and being tongue and groove it is very stout highly recommended!

Was this helpful?

TMR Customs Inc.

Thanks for the 5 star review Steve, much appreciated!